550ml non flammable electrical contact cleaner aerosol spray electronic circuit board equipment cleaner can clean sensitive electronics and electrical equipment. Clean oil, dirt, flux residue and condensation without leaving a residue. Works on large electrical motors, armatures, relays, electric panels and generators.
Features
1. Cleans and protects sensitive electronic equipment.
2. Helps prevent contact failure.
3. Multi-surface, Quick-drying formula.
Use Directions
1. Shut off power and allow any hot surfaces to cool. Make sure all stored power is drained from the system
2. SHAKE CAN WELL
3. Hold can 6”-8” away from the surface and spray directly onto the electronic device or circuit board to eliminate and remove any contaminants that may cause loss of electrical contact
4. Tilt surface while cleaning and allow any excess cleaner to run off
5. Allow product to dry completely and thoroughly vent the system before restoring power
